57
6
Operation in a Telecommunications System
The following points must be considered additionally to or differently to the
operation of the telephone on a direct connection when operating in a tele-
communications system.
6.1
Determining the Exchange Code
The necessary exchange access code can be stored to give direct access
to the line for dialing from a memory (redialing memory / phonebook / call
list / network operator code). Since this stored exchange code should also
be dialed automatically when dialing manually, dialing within the system is
only possible when the system can recognize by means of a special key (*
or #) that an internal number is being dialed. This special key must be
pressed before the phone number for internal calls. The exchange code can
be deactivated by deleting it. However, if the exchange code is transmitted
by the system together with the incoming phone number, no exchange
code may be programmed. Please read the operating manual of your tele-
communications system. If you have problems with the automatic exchange
code you should delete it and save the exchange codes respectively as the
first digit when you save the corresponding phone numbers (phonebook,
network operator) or dial it manually as the first digit when dialing manually,
dialing from the call list or from the redialing memory.
Initial state: Handset on standby
Operating steps:
No.
Description
Input
Display
å∫ç∂™ƒ©ª
¬
8ASE 1
o
Exit programming
4
å∫ç∂™ƒ©ª
¬
68:
0
Z
Enter exchange
code, e.g. "0”
3
å∫ç∂™ƒ©ª
¬
68:
–
6 8
Enter code
number
2
å
∫ç∂™ƒ©ª
¬
–
s 0
Initiate program-
ming
1
56
6.2
Entering the Dial Pause
You can enter a dial pause, which is often necessary for example after
exchange codes, at the appropriate position with "
s 8
”. It is 2 seconds
long.
6.3
Dialing with Network Operator Code
The stored exchange code is pre-dialed automatically when you dial a num-
ber with a network operator code. For internal calls the empty memory
("00”) must be selected for network operator codes.
6.4
Operating in Systems with LCR (Least Cost Routing)
When operating in a system with LCR, please select an empty memory for
the network operator code.
