Hafele 400.50.038, Manual

Page: 62 / 68

62
3.4 Remote control pairing
In order to activate the pairing function, press and release
the ‘REMOTE SET’ button on the control unit, after
which a red LED will fl ash on the control unit.
Now long press (3 seconds) one of the
active remote control buttons.
Multiple control units can be
paired and used with a single
remote control.
Multiple remote controls can be
paired and used with the same
control unit.
Pairing must not be activated during the
track memorization cycle.
To unpair the remote control
from the control unit, press and
release the ‘REMOTE SET’
button, after which the red LED will
fl ash. Press the ‘REMOTE SET’ button again and keep it pressed until the led
stops fl ashing. When the button is released, the red LED will fl ash 5 times to
confi rm the unpairing.
The unpairing of a remote control completely eliminates its association with any
control unit. In order to use the remote control, it will be necessary to pair it again
using the standard procedure.
3.5 Wiring of the control unit switch
The NO switch is a simple, normally open contact controlled by control unit.
No voltage output is supplied from the switch terminals.
The switch can control equipment with a nominal voltage of between 0 and 48V
and a maximum current of 2A.
Wiring for control via the switch must be performed by specialized personnel
according to the wiring diagram supplied.
REMOTE
SET
00:00:03
FREQUENCY: 433,92 MHZ
MAX POWER: 1 mW
DEVICE = 0 - 48V
MAX 2A
SWIT
CH
N/O
A920_Schiebetürantrieb_für_Slido_Flat_60_FB.indd 62 19.08.2019 07:54:46