Häfele HDW-SI60AB, Instruction Manual

Page: 15 / 91

15
INSTALLATION INSTRUCTION
5. INSTALLATION INSTRUCTION
‼
WARNING:
Electrical Shock Hazard Disconnect electrical power before installing
dishwasher.
Failure to do so could result in death or electrical shock.
‼
WARNING:
For personal safety:
•
Do not use an extension cord or an adapter plug with this appliance.
•
Do not, under any circumstances, cut or remove the earthing connection from the
power cord.
Attention!
The installation of the pipes and electrical equipments should be done by professionals.
Electrical requirements
Please look at the rating label to know the rating voltage and connect the dishwasher to the ap-
propriate power supply. Use the required fuse 10A/13A/16A, time delay fuse or circuit breaker
recommended and provide separate circuit serving only this appliance.
Electrical connection
Ensure the voltage and frequency of the power being corresponds to those on the rating plate.
Only insert the plug into an electrical socket which is earthed properly. If the electrical socket
to which the appliance must be connected is not appropriate for the plug, replace the socket,
rather than using a adaptors or the like as they could cause overheating and burns.
Ensure that proper earthing exists before use
5.1 About Power Connection
5.2 Water Supply And Drain
Cold water connection
Connect the cold water supply hose to a
threaded 3/4(inch) connector and make sure that
it is fastened tightly in place.
If the water pipes are new or have not been used
for an extended period of time, let the water run
to make sure that the water is clear. This
precaution is needed to avoid the risk of the
water inlet to be blocked and damage the
appliance.
safety supply hose
ordinary supply hose