7
phase
3
).
7.
Introduce and screw the screws (and washer(s)) up into
the hole(s) for the definitive fixing (
COMPULSORY!!
).
Then, having checked the setting of the hood, TIGHTEN
ALL THE upper and lower SCREWS.
Note:
the lower fixing points are visible removing the fats
filters and they are at the sides and/or at the centre of the
hood (after having removed the frame of the carbon filter,
if present, in the latter case).
In any case, we recommend using the lateral holes, when
available, to increase the stability of the hood.
8.
Connect a tube (tube and bands for fixing not supplied, to
be purchased) for discharging the fumes to the
connection ring placed over the aspiration motor unit.
The other end of the tube should be connected to a
device for expelling fumes on the outside of the hood in
the aspiration version. If you want to use the filtering
version, fix deflector
F
to flues support bracket
G
and
connect the other end of the tube to the connection ring
placed on deflector
F
.
9.
Connect the electricity.
10.
Apply the flues and fix them above with 2 screws (
10a
) to
flues support bracket
„G“
(
10b
).
11.
Slide the lower section of the flue down to cover the
aspiration set until inserting it completely into the
apposite housing over the hood. Remount the carbon
filter frame and the fat/s filter/s and check the perfect
functioning of the hood.
