20
Save Power Mode
To activate or deactivate save power mode,
follow the below steps:
1. Open the door and press the Time Delay
(3) and Extra Dry/Energy Save (4) keys for
3 seconds.
2. 3 seconds later, the machine will show
the last setting, which is “IL1” or “IL0”.
3. “IL1” will be displayed when the Power
Saving Mode is enabled. In this mode, the
inner lamps will turn off 4 minutes after the
door is opened and the machine will turn off
in 15 minutes if no key is pressed to save
power.
4. “IL0” will be displayed when the Power
Saving Mode is disabled. If the Power
Saving Mode is disabled, the inner lights
will remain on as long as the door is open
and the machine will remain on unless it is
switched off by the user.
5. Switch off the machine to save the
setting selected.
Power Saving Mode is enabled in default
factory settings.
Natural Ion Tech (Model Dependent)
This function provides extra hygiene and
prevents unpleasant odors thanks to the Ion
Technology. You can press the Half Load
key (5) for 3 seconds to enable Natural Ion
Tech. After 3 seconds, “Ion” message
will
be displayed to indicate that the Natural
Ion Tech function has been enabled.
Release the key once “Ion” is displayed.
Natural Ion Tech function will be cancelled
automatically in 24 hours unless the user
intervenes.
NOTE:
Natural Ion Tech function will be
cancelled if the machine is switched off.
NOT:
Natural Ion Tech function does
not run together with any program.
Crystalight
(Model Dependent)
Combining Ion and Daylight Technology,
this function provides extra hygiene.
It prevents unpleasant odors during a
washing cycle that contains a drying step.
You can press and hold the Half Lod key
(5) for 6 seconds to enable the Crystalight
function. After 6 seconds, “U1” message will
be displayed to indicate that the Crystalight
function has been enabled. When disabled,
“U0” will be displayed at the end of 6
seconds. The Crystalight setting follows the
Natural Active Technology setting.
It is set to “UO” by default.
NOT:
If the user does not disable the
Crystalight at the end of the program, it will
remain enabled until the machine is turned
off.
NOT:
If you open the door while the
Crystalight or Natural Ion Tech is enabled,
warning LEDs will flash.
