Hafco W618, Operator'S Manual

Page: 10 / 17

10
Turning the handwheel clockwise will raise the infeed table causing less wood to be removed from
workpiece.
Do not make jointing or planing cuts deeper than 3mm.
POSITION THE FENCE
The fence can be position positioned to plain the wood at any angle from 45°inward to 45°outward.
Before adjusting the fence position, make sure the power is turn off.
To adjust the angle of the fence:
⚫
Loosen the fence tilting handle. This handle is spring loaded. To loosen the handle it is necessary to
gently pull the handle away from the fence support release and turn again continue until loosened.
⚫
Manually tilt the fence to desired angle inward or outward. As long as you have set up the machine as
described in the installation instructions part of this manual then, the fence will hit the 45° stops inward
or outward at 45°and measurement should not be necessary. However, it is advisable to always check
your angles before commencing work.
NOTE: The fence has positive stops at 0° (90° from table), 45° inward and 45° outward..
⚫
Once the desired angle has been achieved tighten the tilting handle.
⚫
The fence can be positioned over the blade, so that only the desired width of blade is exposed,
according to the work piece width.
⚫
Slide fence forward to the desired position and tighten fence sliding handle making sure fence is tight
and secure.
ADJUSTING BLADE HEIGHT
CAUTION: Make sure the switch is in the OFF position and cord is unplugged before proceeding with
checking blades.
The blades have been adjusted at the factory to assure proper operation and should require no adjustment.
However, shipping and handling may have caused misalignment. For accurate cutting, the blades must be
Infeed table
Handwheel