6
6
G
G
E
E
T
T
T
T
I
I
N
N
G
G
S
S
T
T
A
A
R
R
T
T
E
E
D
D
Make sure that the electrical supply and the machines voltage are the same. Refer to
the identification plate on the motor for the correct voltage.
Use a good quality grounded electrical system.
All internal and/or internal operations, maintenance or repairs, must be performed in a
well-lit area or where there is sufficient light from extra sources so as to avoid the risk of
even slight accidents.
6.1 Minimum Requirements for Housing the Machine
The Main voltage and frequency complying with the requirements for the machines motor.
Environment temperature from 10°C to +50°C.
Relative humidity not over 90%.
6.2 Anchoring the Machine
Position the machine on a firm and level concrete floor.
Maintain a minimum distance of 800mm from the wall to
rear of the machine.
Anchor the machine to the ground, as shown in the
diagram, using screws and expansion plugs or sunken
tie rods that connect through holes in the base of the
stand.
Ensuring that it is sitting level.
6.3 Assembly and Setup
Take out the accessories (A) and the
coolant tank (B) from inside of the stand
and set aside for later use.
Lift off the stand (C) and place into the
intended working location (D).
Prepare the machine unit for hoisting
Method one: Use a sling. Carefully wrap the sling (E) around the collar of the movable jaw
and motor mount
Method two: Using lift rings. Attach lifting rings to three points on the base of the machine.
Attach a three-point sling with grab or sling hooks to the lift rings (F).
1
B
A
3
E
2
D
C
F
F
F
Page 6
Instruction Manual for CS-315D (S828)
03/12/2014
