7.1 General Advise Before Using the Machine
This machine is designed to cut metal construction materials of different shapes and
profiles. The materials may be required for fabrication workshops, machinist shops, and
general construction work.
Limit the machines use to a single operator.
To obtain good running-in of the machine it is advisable to start using it at intervals of
about half an hour. This operation should be repeated two or three times, after which the
machine may be used continuously.
Always check that the workpiece is securely clamped and that long pieces are suitably
supported.
Do not use a disk size that is outside the limits of the machine specifications.
Immediately release the start/run/trigger button if the disk should get stuck in a cut.
Switch off the machine before raising the machine head. Then open the vise and
remove the workpiece. Lastly, check the disk teeth for any damage. If any of the teeth
are broken, replace the saw blade.
Before carrying out any repairs of the machine, consult a technician.
7.2 Operator Position
The operator should stand in front of the machine using a
single hand to grip the control handle.
7.3 Deactivating the Machine
If the machine is to be inactive for a long period, prepare the machine as follows:
Detach the plug from the electric supply panel
Release the head return spring
Empty the coolant tank
Carefully clean and grease the machine
If necessary, cover the machine.
7.4 Dismantling
General rules
Before disposing of the machine, the machine should be broken down and separated into
the 3 categories as follows:
Cast iron or ferrous materials: These materials should be of single composition, without
combination or attachment to other types of materials. This is a recyclable material. The
materials may be sent to metal scrap and recycling centers.
Electrical components: This includes cables and electronic parts (magnetic cards, etc.).
These materials may be considered as urban waste. Give the materials to your local
public waste disposal service.
Old mineral, synthetic and/or mixed oils: Blend oils and greases are special refuse.
Have these collected by a service specializing in oil disposal.
Note: Standards and legislation for waste disposal is in a state continuous change and
evolution. The user must be informed of current regulation for waste disposal of machine
Page 10
Instruction Manual for CS-315D (S828)
03/12/2014
