Hafco Woodmaster SB-12, Operator'S Manual

Page: 11 / 18

11
Parallel cuts
Adjust the rip fence in accordance with the width of work
piece. With both hands (use the push-stick in the region of
the saw blade) and push the work piece until it is behind the
riving knife. Use the push
–
stick to feed the work piece right
from the beginning of the cutting process if short work
pieces are being used..
Cross cuts
Warning: the work piece must be secured against
rotation by using a suitable jig or holder when
cross-cutting round stock. At the same time a suitable
saw blade shall be used.
Adjust the miter gauge to not touch the saw blade. Only
feed the work piece by means of a cross slide.
Do not remove wood chippings from the region of the work
piece with your hands.
Concealed cutting, rebating
When performing rebating work at the fence rail, select the
cutting sequence which ensures that the cut-off strip falls
onto the side of the saw blade facing away from the fence
rail. Remove the blade guard and the riving knife to perform
concealed cutting or rebating work. Ensure that the work
piece is guided properly. Re-install the guard when finished.
Angle adjusting
hand wheel
Height adjusting
hand wheel
Lock knob