Eclipse Installation, Commissioning & Operating Manual
Approved Document Ref: UI-ECL-01 Issue 8.0
18
SETUP & PROGRAMMING
2
2
2
4
Set fault buzzer volume.
RESOUND
SILENCE
RESET
ENTER
1
2
3
4
Disable
Mode
Test
Mode
Mute
Buzzer
Test
Lamps
There are two levels of volume for the internal fault buzzer, high and low.
Enter the above code and press the ENTER button to increase or decrease the fault buzzer tone from the
previous level.
Setting will change when ENTER button is pressed.
When finished, enter the next programming code or disable the controls and return DIL switch 3 to ‘OFF’.
2
2
1
1
2
2
3
3
Set keypad entry code (fire LED 1 option)
Fire LED 2 future option (not in use)
The keypad can be used to activate the panel controls instead of using the key switch. The default code
is 1-2-3-4, however, this can be changed. It is also possible to disable the use of a code entry to enable
controls, forcing the use of the key switch only.
Enter the above code and press the ENTER button.The Zone Fault/Disabled/Test LEDs will start to rapidly
pulse in sequence to show the currently set code. The sequence will be repeated twice after which time
the panel will automatically drop out of the set keypad entry mode.
Whilst the current code sequence is being repeated start to enter the new code. Enter the new code slowly
and deliberately, one number at a time. The corresponding Zone Fault/Disabled/Test LED will rapidly pulse
to confirm each entry.
Note: Enable Controls codes must always start with a 1 or 2.
When finished entering the new four digit code, press the ENTER button. The panel will then confirm the
new code with rapidly pulsing LEDs in sequence, after which time the panel will automatically drop out of
the set keypad entry mode.
Changing the keypad code to 1 - 1 - 1 - 1 will disable the use of a keypad to enable controls.
