Esento Marine 2-4 Installation, Commissioning & Operating Manual
Approved Document UI-ESEN4MAR-01 Issue 6.0
24
OPERATING
PANEL CONTROLS & INDICATIONS
Fire Detection System
RESOUND
SILENCE
RESET
ENTER
1
2
3
4
Zones in Fire
Zone Fault / Disabled / Test
Supply Healthy
General Fire
General Fault
General Disablement
Test Mode
Sounder Status
Aux Output Status
Power Supply Fault
System Fault
Access Level
1
2
3
4
Zonal Fire Indicator LEDs
Zones In Fault, Zones Disabled or
Zones In Test Indicator LEDs
8 Button Keypad For Controls
And Programming
Status Indicator LEDs
Activate Controls Key Switch
Activate Controls
In normal standby mode the keypad controls are inactive to protect from unauthorised operation. Controls
can be activated by using the ‘Activate Controls’ key switch or by entering a four digit code using the
keypad.
The use of a code entry to activate the controls is enabled by default but can be disabled in the engineering
functions.
To activate the controls using the key switch;
turn the key clockwise to the ‘On’ position. The ‘Access
Level’ indicator LED will light and all buttons on the keypad will now be operational. To deactivate the
controls, turn the key back to the ‘Off’ position and the ‘Access Level’ indicator LED will extinguish.
If the key switch is in the ‘On’ position the keypad will remain active.
NOTE :
It is not possible to remove the key in the ‘On’ position.
To activate the controls using the keypad;
enter the four digit code using buttons 1 - 4. The factory
default code is 1-2-3-4 but can be changed in the engineering functions. After entering the four digit code
press the ‘ENTER’ button. The ‘Access Level’ indicator LED will light and all buttons on the keypad will
now be operational.
After activation by code entry, controls will automatically deactivate again after 2 minutes and the panel
will return to standby mode.
The test lamps and mute buzzer functions are operational without the need to activate controls.
Summary of Contents for ESEN-2MAR
Page 44: ...www haes tech com ...
