Quick Start Guide
AlarmSense PLUS Quick Start Guide
Document Ref: EUFS-UI-ASP-02 Issue 1.0
4
PANEL CONTROLS & INDICATIONS
Zones in Fire
Zone Fault / Disabled / Test
Fire Detection System
RESOUND
SILENCE
RESET
Supply Healthy
General Fire
General Fault
Test Mode
Sounder Status
Aux Output Status
Delay Status
Repeater Fault
System Fault
Off
1
2
3
4
ENTER
General Disablement
Power Supply Fault
Access Level
On
Disable
Mode
Test
Mode
Mute
Buzzer
Test
Lamps
Activate
Controls
Activate Controls
In normal standby mode the keypad controls are inactive to protect from unauthorised operation. Controls
can be activated by using the ‘Activate Controls’ key switch or by entering a four digit code using the
keypad.
The use of a code entry to activate the controls is enabled by default but can be disabled in the Level 3
engineering functions.
To activate the controls using the key switch
Turn
the key clockwise to the ‘On’ position. The ‘Access Level’ indicator LED will light and all buttons on
the keypad will now be operational. To
deactivate the controls, turn the key back to the ‘Off’ position and
the ‘Access Level’ indicator LED will extinguish.
If the key switch is in the ‘On’ position the keypad will remain active.
NOTE :
It is not possible to remove the key in the ‘On’ position.
To activate the controls using the keypad
Enter the four digit code using buttons 1 - 4. The factory default code is 1-2-3-4 but can be changed in
the engineering functions. After entering the four digit code press the
‘ENTER’ button. The ‘Access Level’
indicator LED will light and all buttons on the keypad will now be operational.
After activation by code entry, controls will automatically deactivate again after 2 minutes and the panel
will return to standby mode.
The test lamps and mute buzzer functions are operational without the need to activate controls.
