HAEGER SF-16R.013A, User Instructions

Page: 5 / 40

English - 3
Assemble step (Stand fan)
Your Stand Fan has been boxed unassembled to minimize packaging waste. Each part is
designed to fit together and be disassembled easily for cleaning or storage.
The device must be completely assembled before use! While reading the text it is advisable
to refer to the “Overview of the Components”.
1) Place the base stand (12) on an even surface. Into the hole in the middle of the base
stand, insert the bottom tube (11) and secure it in place using the pad (13) and base
locking screw.
2) Insert the top tube (10) into the bottom tube (11) and secure it with the fastening
screw (9).
3) Insert the control box (7) with motor housing (6) in the top tube and secure it with
the fastening screw (9).
4) Before assembling Motor housing (6), it is necessary to remove the black protective
sleeve of MOTOR shaft.
5) Unscrew rear plastic nut (4) from motor spindle anticlockwise, position the rear
guard (5) onto the motor housing (6). Insert the plastic nut and turn it clockwise to
lock the rear guard (5) into position.
6) Slide the blade (3) onto the Motor housing (6), making sure the motor housing is fully
seated into the blade groove. Screw the blade locking nut (2) anticlockwise to tighten
the blade to the motor housing.
7) Cover the Front guard (1) on the Rear guard (5).
8) Finally, twist the circlip into the specified position with the safety screw (15).
Assemble step
（
Desk fan
）
9) To change into a table fan, just remove the two column tubes of the floor fan and
directly lock the control box (7) to the base stand (12) with pad (13) and base locking
screw (14).