English - 3
Assembly instructions
BASE ASSEMBLY
Put the pedestal pole into the base cap, rotate clock-wise to tighten the pedestal pole into
the base cap. Insert the 4 legs into the base cap, place the unit back to an upright position
Fig.2 & Fig.3.
BLADE AND GRILLE ASSEMBLY
1.
Unscrew the propeller cap (16) from the motor shaft (5) by holding the motor shaft
and rotating the blade cap (16) clockwise.
2.
Unscrew the rear grid nut (3) from the front of the motor cover by rotating it
anticlockwise.
3.
Position the rear grid (4) against the front of the motor cover, ensuring that the
locating pegs on the motor cover are engaged correctly in the holes on the rear grid.
4.
Replace and tighten the grid nut (3) by turning it clockwise.
5.
Push the propeller (2) onto the motor shaft, locating the slot on the back of the fan
blade on to the drive pin that passes through the motor shaft.
6.
Tighten the propeller cap (16) by turning it anticlockwise.
7.
Position and place the front grid (1) to the rear grid (4), and push the front grid (1)
until all the hooks of the rear grid hook the front grid.
Putting into Service
Working place
Choose a suitable location and a non-slip, flat surface.
Never place the device directly next to heaters or other heat sources. There is always the
danger of fire!
Electrical Connection
1.
Connect the device to a duly installed 220-240V~50/60Hz protective contact socket.
2.
Before inserting the plug into the socket. Make sure that the mains voltage to be
used matches that of the device. You can find this information on the nameplate.
Use
Basic Settings
Set the blower inclination angle before starting the device. You can adjust the inclination
angle by tipping the blower casing with both hands.
The inclination angle amounts to
approx. 15°
.
Operating
To select the fan speed, use the selector on the front to set one of the following speeds:
0=
Turn OFF
1 =
Low
2 =
Medium
3 =
High
