English
5
Instructions
Preparation
Before using for the first time, boil fresh water at least three times in the appliance. Use only water without
any additives or ingredients.
Electrical connection
Check whether the electrical voltage that you intend to use is the same as that of the machine. Details are to be
found on the label on the base.
Connected Wattage
The total power consumption of this device can be up to 2200W. With this connected load a separate supply
line protected by a 16A household circuit breaker is recommended.
CAUTION: OVERLOAD:
-
If you use extension leads, these should have a cable cross-section of at least 1.5 mm2.
-
Do not use any multiple sockets, as this device is too powerful.
Use
1.
Place the kettle on a flat surface.
2.
Open the kettle lid with release button. Fill it with water. Fill only up to the maximum mark (MAX). You
can read off the water level in the water level indicator.
3.
Close the lid.
4.
Place the kettle flush on the stand.
5.
Only connect the kettle to a properly installed 220-240V/50Hz safety socket.
6.
Switch to position 1 (ON). The window will become illuminated with a blue colour, indicating that water
is being heated.
7.
After boiling the kettle switches off automatically.
8.
Disconnect the kettle from the mains electricity
Cleaning
WARNING:
-
Always turn the device off before cleaning it and remove the mains plug. Wait until the
device has cooled down.
-
Never immerse the device or the base in water or other liquids.
CAUTION:
-
Do not use any wire brush or other abrasive objects.
-
Do not use any acidic or abrasive detergents.
-
Rinse the water container out with clean water. Then dry it off with a cloth.
-
Clean the housing after use with a slightly damp cloth.
Decalcification
•
The frequency of the decalcifying operation depends on the hardness of the water and on how often the
appliance is used.
Summary of Contents for Blackness EK-22B.023A
Page 2: ...A B C D E...
