hadewe SB2 Series, Manual

Page: 18 / 28

18
Handling instructions
Do not work with tools
which
- are bent or out of balance
- whose shaft is worn out or
- are rusty.
Working with faulty tools
will cause a stronger vi-
bration of the handpiece.
A damage of the ball bearings,
clamping technique or motor
could be the consequence.
Working with high pres-
sure will not improve the
outcome of your work,
since the motor will even be
slowed down. A second disad-
vantage is the stronger impact
on the ball bearings and the mo-
tor, which will shorten their life
span in the long run.
In case of sending the
device by mail remove
the dust filter before.
Only suck up dust or mill-
ing waste, never suck up
larger particles such as
small bits of cotton wool as this
may be get caught in the hand-
piece and lead to blockages.
Always working with max-
imum speed might have a
similar
effect. Please
make sure that the speed setting
you use is according to the work
you are doing and the instru-
ments you are working with.