hadewe HP-S2, Manual, Page: 13 / 28

13
Application
Work Steps
In the following section the order in
which you should use the device is
described.
Additionally, the
individual steps will be explained in
detail. Read the complete manual
before use.
After
you have clamped the
instrument, press the standby button
(9) to deactivate the standby mode.
Use the buttons (3) and (4) to select
a rotation speed. Manufacturers
often provide recommendations for
optimal rotation speeds. However, it
is important that you never exceed
the
maximum recommended
rotation speed. To start the
handpiece motor, press the button
(8).
You can now choose a rotation
direction using the button (5). The
most commonly used direction is
clockwise. Most milling instrument
(steel instruments with steel cutters)
are optimized for clockwise use. The
rotation direction is irrelevant for
diamond cutters and high-grade
corundum sanders in terms of
efficiency. Working anti-clockwise
can be beneficial if, for example, the
dust obscures your field of vision
when working clockwise.
Now, you can turn on the spray by
pushing button (2). By using the
adjusting knob (1), you can set the
amount of the spray liquid.
After setting the speed and the spray
amount, you can start with working.
If you want to take a break or finish
the job, press the standby button (9).
The handpiece motor and spray will
turn off. The handpiece can now be
placed in its holder on the right of the
unit. Alternatively, you can switch
the device to standby by pressing
and hold the button on the foot
switch.
We recommend you disconnect the
device from the mains power supply
if is not going to be used for a while.
This will save electricity. The mains
plug must also be removed when it
comes to retiring the device.