HADEF 62/05, Installation, Operating And Maintenance Instructions, Page: 11 / 26

5.52.420.00.01.07
11
ƒ There are distance tubes (5) and/or washers
(6) situated on the load bars (2) of the trolley.
ƒ Dimension "X" is set by placing washers (6)
from the outer to the inner side ("X" increases)
or from the inner to the outer side ("X"
decreases).
ƒ Washers (6) and rubber discs (depended on
type) leave a distance for the load hook. It is
important that the load hangs in the middle
under the beam so that the two side plates are
equally loaded.
ƒ
The suspension eye (9) (if existent) for bigger
load bolts must still be swivelling after it has
been secured.
ƒ Tighten the hexagon nut (3) and safety nuts (4)
again.
ƒ Check correct flange width "B" and dimension
"X". Adjustment must be repeated if necessary.
1 side plates
2 load bars
3 hexagon nut
4 safety nuts
5 distance tubes
6 washers
7 ---
8 rubber disc (depended on type)
9 suspension eye
6.3 Installation on the beam
1 Tighten the hexagon nut (3) and safety nuts (4).
2 Push on the trolley at the face of the beam flange.
3 If this is not possible, the trolley can also be mounted
on the beam from below.
4 Therefore, remove the hexagon nut (3) and the safety
nut (4) on the side without gear.
5 Pull apart the side plates (1) as far until it is possible to
push the trolley onto the beam flange from below.
Afterwards, push the trolley together to correct gauge.
6 Secure the washers (6) and distance tubes (5) by
tightening the hexagon nuts (3) and the safety nuts (4).
Illustration 3
CAUTION!
The distance "X" between the wheel flanges of the trolley wheels must exceed the flange width "B" of the
beam by 2-3 mm (1-1,5 mm each side).
WARNING!
The hoist must always hang centrally under the beam or under its suspension point.
6.4 Chain container installation
1 Chain container
2 Bolt
3 Safety clamp
ƒ suspend chain container (1)
ƒ fix it by bolts (2) at the provided hole of box
and housing
ƒ protect it with safety clamps (3)
Illustration 4
CAUTION!