5.52.208.01.01.02
13
WARNING!
It is not allowed to use plastic wire ropes or plastic-coated wire ropes.
6.3
Wire rope fastening
There is a plate on the winch indicating the wind up direction.
Standard
Separation partition 250-500kg
Separation partition 1000-1500kg
Illustration 1
Illustration 2
Illustration 3
*For winches subject to approval by Germanischer Lloyd, at least 3 rope layers are prescribed to remain on the drum.
fasten the sharpened end of the wirerope acc.of suitable image.
make sure that screws and rope key are thighten fast.
Ropefastening for 5000kg at gearside, all others at the opposed limit disc
DANGER!
In case of incorrect winding direction, the load pressure brake is not working.
6.4
Winding up of wire rope
The wire rope must always be winded up tensioned. When the last wire rope layer is winded onto the drum,
the flanged wheel must exceed the top layer by at least 1 1/2 times of the wire rope diameter.
NOTICE!
According to validated regulations and accident prevention regulations, the wire rope length must be
chosen so that at least 2 rope layers remain on the drum when the wire rope is unwinded.
6.5
Wire rope deflection
Wire rope pulleys must be installed in a
position centrically to the rope drum.
In order to ensure correct winding up of the
wire rope on the drum, the max. wire rope
deflection angle must not be exceeded.
maximum wire rope deflection angle
4° for standard wire ropes
2° for non-twisting resp. twist-resistant wire
ropes
The minimum dimension (M) from the drum
until the middle of the pulley must be adhered
to.
Illustration 4
