HADEF 11/09, Installation, Operating And Maintenance Instructions

Page: 14 / 16

14
5.52.189.00.01.05
CAUTION!
Do not use grease for lubrication of load chain.
Without lubrication, manufacturer's warranty and/or liability will be void.
13.2 Pulleys
13.3 Load hook
ƒ Check bearings and pulleys yearly
ƒ
Clean and lubricate the bearings of hooks and pulleys with grease
ƒ Slight bearings are maintenance free
ƒ When bearings resp. slight bearings are worn of, change the complete pulley
13.4 Gear
Regular checks of lubrication are necessary. The teeth must be cleaned and re-lubricated after approx. 3
years. We recommend to use a lubricant of class EP2 or similar products. In case of severe conditions of
use (e.g. dust, regular lifting of the nominal load,etc.), please shorten maintenance intervals.
13.5 Gear spring pressure brake
During the check, brake lining wear is verified. The brake linings must be replaced when the wear limit is
already reached at one position of the lining, - as this can be the case when wear of the linings is irregular.
CAUTION!
The brake linings must be free from fracture. Avoid oil, grease, dirt and humidity on the brake linings as this
increases wear.
13.6 Overload protection
DANGER!
The factory setting of the overload protection/slipping clutch is secured by sealing. In case of any changes
will void the warranty. Should maintenance be necessary, please contact a service company authorized by
the manufacturer.
Use Recommendation Interval
Load chain
oil for example: FUCHS RENOLIN PG 220
or special chain lubricant
Use
NO
grease!
0,2 l 3 month
Use Recommendation Interval
Pulleys
FUCHS
RENOLIN PG220
Acc. to demand 12 month
Use Recommendation Interval
Load hook
bearing FUCHS
RENOLIN PG220
Acc. to demand 12 month