Kit 9:
The first two torpedo tubes
Kit 9:
The first two torpedo tubes
2
3
Separate both parts
E
from frame
9-6
. Note: from stage 2 onwards
some photos of the torpedo tubes show part
E
incorrectly positioned.
See the following step (step 6) for the correct placement.
Take torpedo tube 3
9-2
(with a 3 marked on it). Separate the two
P
parts from frame
9-8
.
Take torpedo tube
9-1
(with the 1 circled). Separate the two
Q
parts
from frame
9-8
. Apply some glue to the inside of the fi rst part
Q
and fi t it onto the recess on the torpedo tube, as indicated above.
Study the photo carefully to check the correct orientation of the
parts. Note that there are notches in part
E
that should be at the
top (arrows). After test-fi tting, apply a small amount of glue to
the inside of each piece
E
and attach them to the ends of the two
torpedo tubes
9-1
and
9-2
.
Apply some glue to the inside of both parts
P
and fi t them into the
recess encircling torpedo tube
9-2
, as shown above.
Repeat the process to glue the second part
Q
to the other half of
the recess around the torpedo tube. The two pieces should join
together seamlessly.
5
3
1
6
4
2
STAGE 1
First details
9-8
9-1
9-2
9-6
9-1
Q
Q
Q
Q
9-8
P
9-2
P
P
E
9-2
9-1
Remove the two parts marked
G
from frame
9-7
.
Glue the fi rst diverter
9-5R
to the peg at the end of torpedo tube
9-2
, in the position indicated by the arrow.
Separate the two parts marked ‘R’ (circled) from frame
9-5
,
indicated by the two arrows. Separate the two parts
J
from
frame
9-7
Glue one of each part
G
into the small hole at the rear of the two
torpedo tubes
9-1
and
9-2
.
In a similar way, attach the second diverter tap in the same
position on torpedo tube
9-1
, as shown above.
Combine one each of
J
and
9-5R
to make two identical diverter
taps, one for each tube. Apply some glue to the contact surfaces
before fi tting together.
5
3
1
6
4
2
STAGE 2
Fitting the diverter taps
9-2
9-2
9-5
9-7
G H I
J
K
L
9-5R
J
J
9-5R
9-1
9-5R
9-7
G
9-1
G
PACK_3 _UK.indd 4-5
02/08/2023 15:38
