Hach LT 200, User Manual, Page: 4 / 272

Table of Contents
1 Specifications on page 4
2 General information
on page 4
3 Installation on page 6
4 User interface and navigation
on page 8
5 Startup on page 9
6 Operation on page 9
7 Maintenance on page 12
8 Troubleshooting on page 13
9 Replacement parts and
accessories on page 13
Section 1 Specifications
Specifications are subject to change without notice.
Specification Details
Dimensions 25 x 14.5 x 31 cm (9.8 x 5.7 x 12.2 in.)
Weight Single heating block: 2 kg (4.4 lb)
Dual heating block: 2.8 kg (6.17 lb)
Power requirements 100–240 V, +5%/–15%, 50/60 Hz,
Protection Class I
Power input Single heating block: 115 V: 300 VA; 230 V:
450 VA
Dual heating block: 115 V: 600 VA; 230 V:
900 VA
Storage temperature –40 to +60 °C (–40 to +140 °F)
Operating temperature 10 to 45 °C (50 to 113 °F)
Operating humidity 90% (non-condensing)
Temperature range LT 200: 37 to 150 °C (98.6 to 302 °F)
DRB 200: 37 to 165 °C (98.6 to 329 °F)
Timer: 0 to 480 minutes
Specification Details
Temperature stability LT 200: ± 1 °C (± 2 °F)
DRB 200: ± 2 °C (± 3.5 °F)
Heating rate LT 200: From 20 to 148 °C (68 to 298 °F) in
10 min (to DIN 38409-44)
DRB 200: From 20 to 150 °C (68 to 302 °F)
in 10 minutes
Certification CE and cTUVus
Altitude 2000 m
Environmental conditions Indoor use
Pollution degree 2
Overvoltage category II
Enclosure rating IP20
Section 2 General information
In no event will the manufacturer be liable for direct, indirect, special,
incidental or consequential damages resulting from any defect or
omission in this manual. The manufacturer reserves the right to make
changes in this manual and the products it describes at any time, without
notice or obligation. Revised editions are found on the manufacturer’s
website.
2.1 Safety information
The manufacturer is not responsible for any damages due to
misapplication or misuse of this product including, without limitation,
direct, incidental and consequential damages, and disclaims such
damages to the full extent permitted under applicable law. The user is
soley responsible to identify critical application risks and install
appropriate mechanisms to protect processes during a possible
equipment malfunction.
4 English