Hach AISE sc, Addendum To The Operator Manual

Page: 7 / 152

English 7
Operation
Calibration (continued)
Sensor code Entry of the sensor code
Lab value correction The laboratory values of the last matrix correction can be changed
Enter the lab value.
Enter the laboratory values if 1-point matrix correction or 2-point matrix correction has
been selected
Ammonium
1,2
Entry of ammonium laboratory value
Nitrate
1,3
Enter the laboratory value for nitrate
Potassium
1,2
Enter the laboratory value for potassium
Chloride
1,3
Enter the laboratory value for chloride
Confirm the entry. Confirm the values entered
Correction result Display the correction results
NH
4
–N
1,2
Displays whether or not the ammonium correction was successful
NO
3
–N
1,3
Shows whether or not the nitrate correction was successful
K+
1,2
Displays whether or not the potassium correction was successful
Cl
1,3
Displays whether or not the chloride correction was successful
Information Information on the matrix correction used per parameter
NH
4
–N
1,2
Matrix correction used for ammonium
NO
3
–N
1,3
Matrix correction used for nitrate
K+
1,2
Matrix correction used for potassium
Cl
1,3
Matrix correction used for chloride
Settings
Name
Enter or edit the name.
Up to 10 alphanumeric characters
Unit Select either mg/L or ppm as the measurement unit
Parameter Select NH
4
–N or NH
4
and/or NO
3
–N or NO
3
Temperature Selection of °C or °F as temperature unit
Offset temperature Enter a temperature offset
Response time Entry of the response time (30 sec to 300 sec)
Datalog interval
Select the data log interval (OFF, 30 sec, 1 min, 2 min, 5 min, 10 min, 15 min and
30 min), 5 min is the factory setting
K+ compensation
1,2
Select automatic potassium compensation:
On
Off
0 = compensation OFF
0.1–2000 mg/L Cl = Fixed compensation value
K+ concentration
1,2
Only shown when K+ COMPENSATE is OFF
Cl - compensation
1,3
Select automatic chloride compensation:
On
Off
0 = compensation OFF
0.1–2000 mg/L Cl = Fixed compensation value
Cl - concentration
1,3
Only shown when Cl COMPNSATE is OFF
Reset configuration Resets the configuration to the factory setting
Maintenance
Sensor information Information on the connected sensor
Sensor type Name of the connected sensor
4.2 Sensor setup menu (Continued)