HACH LANGE 9184sc, User Manual, Page: 22 / 50

20
Operation
4.4 Sensor Diagnostics Menu
SELECT SENSOR
ERROR LIST— See section 6.1 on page 29 .
WARNING LIST— See section 6.2 on page 29 .
4.5 Sensor Setup Menu
SELECT SENSOR (if more than one sensor is attached)
CALIBRATE
ZERO CAL
See section 4.6.4 on page 24 .
PROCEESS CONC
Use to adjust concentration which requires accurate pH; and TFC in ppb. See section 4.6.3 on page 23 .
PROCESS TEMP
Use to adjust the TEMPERATURE for a °C value. See section 4.6.1.1 on page 22 .
PROCESS PH (9184sc T.F.C. or 9184sc Ch Acid only)
Use to adjust for a 1 or 2 Point Process pH Sample. See section 4.6.2.1 on page 22 and section 4.6.2.2 on page 23 .
CAL CONFIG
Select OUTPUT MODE, CAL ZERO, or CAL DELAY. For the OUTPUT MODE, select ACTIVE, HOLD, TRANSFER, or
CHOICE. For CAL ZERO, select ELECTRICAL or CHEMICAL. For CHEMICAL use a sample that does not contain any
oxidants. Ensure that the sample source has a sufficient flow rate and that the sample is adequately mixed. CAL DELAY
can adjust for Days. See
section 4.6.5 on page 25 .
DEFAULT SETUP
Resets the sensor configuration to default settings. See section 4.7 on page 25 .
CONFIGURE
EDIT NAME
Enter up to a 10-digit name in any combination of symbols and alpha or numeric characters.
SELECT PARAM.
Select CHLORINE HOCL, CH ACID, T.F.C., OZONE, or CHLORINE DIOX.
CONC UNITS
Select for ppb–ppm and ug/l–mg/l
T-SENSOR
The sensor has a factory-set internal temperature. Select AUTOMATIC or MANUAL setting. The preferred setting is
AUTOMATIC.
TEMP UNITS
Select °C or °F.
SAMPLE PH (9184sc Ch Acid only)
Allows user to set the pH of the sample.
SELECT PH MEAS (9184sc T.F.C or 9184sc Ch Acid only)
AUTOMATIC or MANUAL setting and pH compensation. Use the AUTOMATIC setting when using supplied pH.