7
Cooling mode
Set desired temperature
with the arrows on the
control panel or the remote
control.
Set temperature is shown
in the display for few
seconds. After, the display
returns to show the room
temperature.
Sleep mode
When in cooling mode,
press the TIMER and
down arrow together to
enter sleep mode. In sleep
mode, the fan is runs on
low speed and set tempe-
rature will increase with
2°C over a course of four
hours.
Dehumidify
In dehumidify mode, the
fan will run on low speed
only. Temperature cannot
be set.
Fan mode
The compressor stops and
only the fan will run. Tem-
perature cannot be set.
3. Set timer
To set timer for shut off,
press the TIMER button
when the unit is operating.
To set timer for start, press
the TIMER button when
the unit is switched off.
Set time with the up and
down arrows on the control
panel or remote control
When the timer is acti-
vated, a light is shown on
the control panel.
Press the TIMER button
twice within 5 seconds to
deactivate the timer.
4. Set fan speed
Press the FAN button on
the control panel to choose
fan speed. On the remote
control, press the HIGH or
LOW button to choose fan
speed.
5. Celsius/Fahrenheit
On the control panel,
press the up and down
arrows at the same time
to switch between Celsius
and Fahrenheit. On the
remote control, press the
°C/°F button.
Water drainage
Empty the water tank
Unscrew the drain cover
and remove the water
stopper. Empty the water
tank and re-attach the
water stopper and drain
cover.
Connecting a water hose
for direct drainage
Unscrew the drain cover
and remove the water
stopper. Attach a 13 mm
water hose to the pipe on
the unit. Lead the other
end of the water hose to
a drain. Make sure that
the water can be drained
downwards.
The air filters
The air filters keep dust
and dirt from entering the
air conditioner.
It is very important that the
filters are cleaned regular-
ly; otherwise the unit may
be seriously damaged.
Therefore, clean the filters
at least once every two
weeks.
Filter cleaning
• Remove the back and
side filters.
• Clean the filters with
warm water and a mild
detergent.
• Make sure that the filters
are fully dried before
reinserting them.
Maintenance and
storage
• Clean the body of the
unit with a soft cloth. Do
not use strong solvents
as this might damage
the surface of the unit.
• Store the unit in a dry
environment, away from
direct sunlight. Drain the
water before storage.
Warranties and
service
2 years product warranty.
The warranty is only valid
with proof of purchase.
For all service and warran-
ty claims, you should first
contact your retailer.
English