6
7
Security warnings:
• The unit must be instal-
led in accordance with
national wiring regula-
tions.
• If the power cord is
damaged, it must be
replaced by qualified
personnel.
• Children should not play
with the unit.
• The unit is for indoor use
only.
• Do not switch the unit off
by unplugging its power
cord.
• Do not put any objects
into the unit’s air inlet or
outlet.
• Keep the unit away from
water sources.
• Place the unit on a flat
and solid surface.
• Keep the unit away from
heat sources and inflam-
mable goods.
• Do not use the unit
in cooling mode if the
ambient temperature is
above +35°C.
• The maximum length
of the exhaust hose is
1500 mm. Do not extend
or use a longer hose as
this might seriously da-
mage the air conditioner.
• Do not bend or flex the
exhaust hose more than
45° to ensure sufficient
air flow.
• The remote control uses
AAA batteries. Use
alkaline batteries only.
Do not use rechargeable
batteries.
Installation
• If the unit has been
transported horizontally,
keep it in an upright po-
sition for 2 hours before
using it.
• Place the unit on a flat
and solid surface.
• Do not install the unit in
bathrooms or other wet
environments.
• Make sure that air flow
isn’t blocked - always
keep at least 50 cm
distance to surrounding
surfaces.
I
nstalling the exhaust
hose
• Attach the adapter to
one end of the hose and
connect the other end
to the back of the air
conditioner.
• Extend the exhaust
hose and lead it outside
through a door or win-
dow.
Using the window kit
• To use the window kit,
To use the window kit,
open the window and
place the window kit
either horizontally or
vertically, depending on
the window.
• Adjust the length of the
window kit and fas-
ten it with the screws.
Shut the window and
attach the adapter on
the exhaust hose to the
window kit.
Protection functions
Automatic defrost
The unit will automatically
defrost when needed. In
defrost mode, the display
shows E4 and no buttons
except the POWER button
are active.
Compressor protection
The unit has a compressor
protection function causing
a 3-minute start delay after
the unit is restarted.
Water full alarm
When the water tank is full,
the unit will stop working.
The water-full indication
light is illuminated and the
display shows FL. The unit
will automatically restart
when the water tank is
emptied.
Operating instructions
1. Starting the unit
Press the POWER button
to start and stop the unit.
2. Select mode
The unit has 4 different
modes; cooling, dehumidi-
fy, sleep and fan mode.
Press MODE on the con-
trol panel to select mode.
On the remote control,
each mode has a corres-
ponding button.
English