!
I. INTRODUCTION
Stationary massage table LIBRA 4 enable the physiotherapist correct, safe and effective
rehabilitation treatment, physiotherapy, physical therapy, massage, aimed at treating or
alleviating the course of diseases and the effects of injuries. Construction of stationary massage
table LIBRA 4 allows the physiotherapist full and easy access to the patient from all sides.
II. INSTALLATION
•
Make sure that the table is put on hard and flat floor.
•
If the bed turns or tilts due to uneven ground, adjust the feet using screws.
Connection to the electricity
Before inserting the plug into a socket outlet, make sure that:
•
The socket is properly grounded and complies with the applied regulations.
•
The socket is able to withstand the maximum load of the appliance, specified in Technical Data
section.
•
The electric voltage in the network is consistent with the data given in Technical Data section.
•
The socket corresponds to the plug. If not, replace the socket.
Do not install the devices in the open air. Electric actuators can work no longer than 2
minutes. Restarting is possible after 18 minutes of rest.
After installing the table, the socket outlet should be easily accessible.
Do not use electrical extension cords.
The cable should not be bent.
The power supply cable may only be replaced by an authorized specialist.
Do not make any repairs to the electric actuators yourself.
Avoid direct sunlight, UV radiation, rain, excessive dust, moisture.
Attention!
The manufacturer declines all responsibility if the user don't follow the above mentioned
rules.
7
EN
