V. EXPLOITATION REMARKS
•
Use the table in accordance with the instruction manual.
•
Damages caused by wrong using (inconsistent with the above mentioned remarks) cannot be
complained.
•
The device is not intended for use by person with reduced physical or mental agility and
people without any adequate experience and knowledge, unless they use it under supervision
or after receiving directions from a person responsible for their safety.
•
The table should only be used by adults and in accordance with the instruction manual.
•
The table is intended for use inside the dry and closed rooms and for treatment of one person
only at a time.
•
It is not allowed to move the table with the patient.
•
It is forbidden to sit on the table rapidly (jump on).
•
It is forbidden to sit down, kneel down and lean on the headrest, shelves and armrests.
•
If the patient lays down on the table without clothes, the physiotherapist should use
disposable covers or disinfect the table.
•
Long-term contact of the table upholstery with oils should be avoided. For this purpose, use
oil-resistant cover or waterproof sheets.
•
The table should be used and stored away from direct sources of fire and heat.
•
The table should not be exposed to long-term sunlight. This can cause discoloration of the
table upholstery.
•
After bringing the table from a cold room, connect it to the electricity network after 15
minutes waiting.
•
It is recommended to make full height adjustment of the table in the range from minimum to
maximum to ensure that the lubricant is evenly distributed inside the motor. It ensures the
correct maintenance of the table and extends the engine life. The operation must be repeated
2, 4 times min. once a week.
•
Do not remove the plug from the socket by pulling the cable.
•
Do not disassemble the device and try to get inside it.
IV. TABLE TOP HEATING:
The bed warms up by degrees. After about 10-15 minutes of heating, the temperature of the
PU leather surface is about 31-35
℃
.
When upholstery degrees up to max temperature around 35
℃
, the power connection switches
off. When upholstery comes down 4~5 degrees, the blanket will work again . This circulation will
repeat . We suggest the continuous control of heating function within 2 hours.
Caution!
The heating effect is affected by ambient temperature. If the environment
temperature is high, the heating speed is faster, the final temperature is a little bit higher that
standard temperature; if the environment temperature is low, the heating speed is slower, the
final temperature is a little bit lower than standard.
9
EN
