HABCO® TECHNICAL DOCUMENT - C096832 • 10126169
© HABCO Manufacturing Inc. “HABCO®, Cassette®, Cold Space Merchandiser®” are registered trademarks of HABCO Manufacturing Inc. Domestic and International Patents. Page 12
ure to maintain unobstructed door closure will lead to damage not
covered by HABCO® Limited Commercial Warranty.
9. Cleaning the Magnetic Positive-Seal Gasket: A mild solution of anti-
bacterial detergent and warm water with a damp cloth or sponge
should be used to clean all appliance door gaskets. Do Not Pull, Re
-
move, Place Undo Stress on, or Submerge Any Door Gaskets While
Cleaning.
10. Pilaster Removal for Cleaning: Remove product and shelving. Re
-
move each pilaster strip and clean beneath. Replace pilasters.
11. Air Distribution Panel Removal for Cleaning: Remove pilasters and
rear Air Distribution Panel. Carefully remove Air Distribution Panel
from cabinet ensuring that edges do not scratch interior surfaces.
Sanitize surfaces and reinstall Air Distribution Panel.
12. Preparing the Refrigerator for Extended Shutdown & Storage:
WARNING: RISK OF ENTRAPMENT! WHEN STORING, ENSURE THAT DOOR
IS BLOCKED SLIGHTLY AJAR, BUT SECURED NOT TO OPEN.
NOTICE: RISK OF APPLIANCE DAMAGE! DO NOT STORE OUTDOORS, IN DI-
RECT SUN, DAMP, EXTREME HEAT AND/OR COLD CONDITIONS.
i.
Disconnect power to refrigerator. Clean thoroughly following
section J instructions. Remove shelving and clean according
to instructions. Leave an open box of baking soda inside with
door blocked slightly ajar, but secured not to open. Cover en
-
tire refrigerator with appropriate, breathable cover.
K. TROUBLE-SHOOTING
Prior to calling for service, check the following:
•
Is the appliance plugged-into dedicated, grounded 3 prong wall
receptacle?
•
Is the circuit breaker thrown or fuse blown?
•
Is there adequate power?
•
Is the circuit prone to power fluctuations?
•
Are there other appliances on the same circuit drawing power?
•
Has an extension cord, power bar or adapter, been improperly
used to connect power?
•
Is the appliance overloaded with product?
•
Is there adequate ventilation?
•
Is the condenser plugged with grease and/or dirt?
•
Are the doors closing properly?
•
Do the gaskets seal snugly?
•
Is the lower guide track free from debris and spillage?
•
Are the shipping pods/shipping pallet removed and is the appli-
ance level?
Information to Provide to Qualified Service Professional:
•
Serial Number of appliance (upper left interior wall);
•
Appliance Installation Address and Contact Information;
•
Installation Location Hours of Operation;
•
Nature of Problem;
•
Any reports of power interruptions;
•
Recent service or maintenance completed on appliance;
•
Has the appliance been relocated from original installation;
•
Clear access to the appliance;
•
Safety, Installation and Instruction Manual.
