Operating instructions 36007
Hot-pressing device
PQ-58
Page 16 of
20
Edition: 04/0312
Subject to alterations
9.2
Cooling tongs CD-60, CD-54
The cooling tongs CD-60 and CD-54 are designed for the rapid cooling of the joint, still within the
guide rail
→
ill. (6). After the specified pressing time has elapsed, the cooling tongs must be clamped
onto the guide rail as quickly as possible.
If the cooling tongs are used repeatedly at short intervals, they get warm. They may be cooled by
dipping them in cold water.
Illustration 6
9.3 Preparing
devices
9.3.1 Scissors for cutting to length AQ-40
The scissors for cutting to length AQ-40 permit clean cutting of the tapes at a 60° angle. Tapes up to 40 mm
/
1.57 in.
wide and 3 mm /
0.12 in.
thick can be cut to length with these scissors
→
ill. (7).
9.3.2 Flexproof cutter AF-102
The Flexproof-Cutter AF-102 is a device for preparing (finger cutting) Habasit machine tapes up to a width of
100 mm/
4 in
. and a thickness of 2 mm/
0.08 in.
for Flexproof (finger) joints. It is suitable for the standard
Habasit 8 x 30 mm finger geometry. The tape is positioned and securely clamped on an aluminum support.
Fingers are then cut manually. The cutter is precisely positioned on the support with a pin matching a row of
precisely cut indexing grooves; the angle is given by a guiding block fixed to the cutter.
→
ill. (8).
Illustration 7
Illustration 8
