HAAS + SOHN HSP 8 Home 445.08, Equipment Sheet

Page: 7 / 25

Cleaning
work
3
3. Cleaning work
WARNING
Before starting any cleaning work, the stove must be cool down and set to "Off"!
Once the cleaning work is completed, the correct operating status of the device must be re-
established: Put the combustion pot in correctly, close the combustion chamber door.
3.1. Cleaning the surface
Dirt on the upper surface of the stove may be cleaned off with a damp cloth or if necessary with mild soapy
water. You are advised against using corrosive cleaning agents and solvents since these might damage the
surfaces.
3.2. Cleaning the glass panel
To clean the viewing panel, you must first open the stove door. Dirt on the glass panel can be removed with a
glass cleaner or with a damp sponge on which you have sprinkled some of the wood ash present.
(Environmentally friendly). Cleaning the glass panel may only be done with a cooled down stove in the OFF
operating mode.
3.3. Clean combustion chamber “function instruction” error
F040
• The entire combustion chamber is to be cleaned with an ash vacuum cleaner at intervals of no longer than
30 operating hours .
• However, this instruction to clean the combustion chamber (display flashing) does not trigger an error
message during Heating mode.
• If the combustion chamber is now cleaned, then the “Clean combustion chamber” error message will
thereafter be cleared automatically. A precondition for the automatic clearance of this error message is that
the combustion chamber door is open for longer than 60 seconds. This time is required for cleaning the
combustion chamber including the burner thoroughly with an ash vacuum cleaner. If the door is open longer
than 60 seconds in “Off” operating status, then the operating hours counter, which is responsible for the
“Clean combustion chamber” instruction, is automatically reset to zero.
• This reset of the operating hours counter occurs even if the cleaning of the combustion chamber is
performed before the 30 operating hours have run provided that the stove is in “Off” operating status and the
door is open for longer than 60 seconds during cleaning.
3.4. Cleaning the combustion pot -weekly
During operation, deposits may form in the combustion pot. How quickly the combustion pot becomes dirty
depends solely on fuel quality. The deposits or encrustations must be removed from time to time.