Fig 3
8) Press the Power Button to turn the unit on. The
unit will heat up in less than 40 seconds. once
you see that a steady steam vapor is emitted from
the steam head, the Steam Station is ready.
9) Hold the wand of the steam head firmly and
slowly move it up and down, and then across the
garment surface until the wrinkles are removed
to your satisfaction. Always keep the steam head
positioned with the steam jets pointing away from
you and horizontal to the garment surface. (Fig 4)
10) When there is no more water in the tank, the Water
Refill indicator light will light up. (Fig 5) Hang the
steam head in the resting prongs. Turn your garment
steamer off and unplug the unit. Refill the tank as
directed in Step 5, plug the unit in and continue
steaming as before.
11) When you have finished using the Steam Station
™
,
turn the Power Button to the oFF position and unplug
the unit. if you will not be using the unit again soon,
be sure to drain all the remaining water from the
tank by opening the Excess Water Removal Valve
(Fig 6) and emptying the excess water into a sink.
HAAN
®
Helpful Hints:
To use the Garment Valet most effectively:
• Extend both sides of the hanger, turn the grooved
tubes on each side of the support until tightened
(as described in assembly instructions pg
6-7) and
hang the steam head wand between the prongs at
the top of the valet. (Fig 7) Align the shoulders of
the garment on the hanger and allow it to hang freely.
• Since clothing is hung from the support and hangs
freely, the pressure on the garment may be weak.
Therefore, you can use the clips on the bottom
crossbar to anchor the bottom of the garment to
provide tension. (Fig 8)
• When attending to detailed pressing of a garment,
one hand can be used to control the wand of the
steam head and the other hand, in the Pressing
Operating Instructions:
(cont)
OFF ON
Fig 4
Fig 5
ON
needs
water
Fig 6
Plug
Fig 7
Fig 8
www.
HAAN
USA.com 877-HAAN DIRECT / 877-422-6347
pg 9
Using Your Steam Station
™
