Position 5-7: older brushes to eliminate wear on brush parts.
Position 8: Service position for removing the front wheel shaft including the brush when servicing
or repairing the machine.
Emptying waste bin:
Dump and clean the waste bin regularly. To open the container, fold the push handle to upright po-
sition. Lift the container handle upwards and disconnect the waste bin. After emptying place the
container back into place and push the holders down to secure the container to In its place. The ma-
chine is ready to continue in sweeping
Brushes:
Rotary disk brushes and roller brush can be cleaned with water. (do not use high preasure washer!)
Brush bristles are made of polyamide. If the bristles are bent due to poor storage warm it up and
bring it to the original working position by using hot air flow (eg hairdryer) you can also se warm
water.
(Do not use open Fire or burners and close to intense heat!)
LEAFLET: accumulated dirt may adversely affect the functionality and life of the Sweeper.
Please keep and clean your sweeper regularly. This gives you a trouble-free sweep function and
long service life.
Battery charging:
Charging of battery must be done with the original charging device included in the package.
Recharging should be carried out in a dry and well-ventilated room. Sweeper must be switched off
during t hecharging. To charge, insert the charging connector into the slot (item 10.02) and connect
the adapter cable. When battery fully charged, disconnect the cable from charging socket. Sweeper
is ready to use.
To Charge the battery takes 4-6 hours. Always store the sweeper with a recharged battery to prevent
the battery from running out of power for a long time storage. During long storage, recharge the
battery every two months for 10 hours.
