094252_c_gb_hebvrr_s
haacon hebetechnik gmbh – Phone +49 (0) 9375 - 84-0 – Fax +49 (0) 9375 - 8466
4
10.3 Delivery
The electric drive unit for the lifting device Type 889 consists of the following:
2 gear motors
control box
2 drive cables
2 limit switch cables
4 fitted limit switch casings
installation kit (connection flange, mounting bolts, etc.)
10.4 Mounting
Connect the gear motors with a positive connec-
tion and so that they are protection from torsion
by inserting the drive square into the mounting
hole on the gear of the support marked ‚
1
‘ or ‚
2
‘.
Secure the gear motors during the lifting process
to prevent their coming away by inserting the
locking spring in the stop bolt.
Connect the connection cable for the gear
motors to the corresponding connector on the
support and secure it.
Connect each pair of supports via a limit switch
cable using a screw connector.
Important: The cable ends have socket and plug
connectors.
Connect the drive cables to the supports marked
‚
1
‘ and ‚
2
‘ and secure them.
Important: The cable ends have socket and plug
connectors.
Connect the drive cable to the control box and
secure it.
Important: Connect the drive cable from support
‚
1
‘ to connector ‚
1
‘ on the control box and con-
nect the drive cable from support ‚
2
‘ to connec-
tor ‚
2
‘ on the control box.
10.5 Operating
To avoid any risk to persons and the lifting device, before you raise the container ensure that
→
The container has been released from the carrier vehicle.
→
The rack supports have been correctly mounted in their operating positions.
→
The control and power cables have been connected properly.
→
The lifting capacity has not been exceeded.
→
At the end of the lifting process or if it is interrupted, the main switch on the controller is always
turned off.
The adjustment to the ground conditions is conducted across the container by hand using the crank handle and
along the container using the electric drive unit (see point 7).
Do not operate the device without supervision.
If the device is not in use cover the connectors with safety caps.
→
Connect the extension cable (not supplied) for the power connection to the control box and to the power
supply.
→
Switch the main switch to "ON".
→
You can now complete the following functions using the joystick.
The operator must be positioned on the drive side of the container.
–
–
–
–
–
–
.
2.
3.
4.
5.
6.
Drive cable
Locking spring
Connection cable
Limit switch cable
Drive square
Drive cable
Locking spring
Connection cable
Limit switch cable
Drive square
