2-2
Installation flowchart
Figure2-1 Installation flowchart
Mounting the device on a workbench
CAUTION:
Do not place heavy objects on the device.
If a standard 19-inch rack is not available, you can mount the device on an anti-static workbench in
the equipment room.
To mount the device on a workbench:
1.
Place the device upside down. Clean the recessed areas on the chassis bottom.
2.
Attach the four rubber feet to the recessed areas on the chassis bottom.
3.
Place the device on the workbench with the upside up. Make sure the four rubber feet stand
firmly on the workbench.
Start
End
Determine the
installation position
Install the device on
a workbench
Ground the device
Power on the device
Troubleshoot the
device
Power off the device
Operating
correctly?
No
Install the device in
a 19-inch rack
(Optional) Install
network port
lightning arresters
(Optional) Install a
surge protected
power strip
Connect the AP to
the network
Connect power
cords
Mounting the device
on a wall