H3C WA6528X-E, Installation Manual

Page: 34 / 42

2-24
Some Intel wireless adapters do not support 802.11ax. For clients to detect Wi-Fi 6 networks,
upgrade the driver for the wireless adapter to the most recent version. For more information, see
the official statement of Intel .
To log in to the AP through a wireless connection:
1. Enable WLAN on the configuration terminal and access WLAN H3C_xxxxxx , where xxxxxx is
the last six bits of the AP's MAC address.
2. Enter
telnet myap.h3c.com
from the CLI of the terminal.
3. Enter the default username and password.
Anchor mode
When the AP operates in anchor AC mode, only wired connections are available.
To log in to the AP through a wired connection, enter the management IP address of VLAN-interface
1 from the CLI of the configuration terminal. If the default IP address has been changed, contact the
administrator to get the new IP address.
Logging in from the Web interface
By default, HTTP and HTTPS are enabled and the following login information is defined for your
login:
•
Username —admin.
•
Password —h3capadmin.
•
Management IP address of VLAN-interface 1 —192.168.0.50 with subnet mask
255.255.255.0.
Cloud mode
When the AP operates in cloud mode, only wireless connections are available. The configuration
terminal must be enabled with DHCP.
Some Intel wireless adapters do not support 802.11ax. For clients to detect Wi-Fi 6 networks,
upgrade the driver for the wireless adapter to the most recent version. For more information, see
the official statement of Intel .
To log in to the AP through a wireless connection:
1. Enable WLAN on the configuration terminal and access WLAN H3C_xxxxxx , where xxxxxx is
the last six bits of the AP's MAC address.
2. Visit http://wlan.h3c.com from a browser, and then press Enter .
Visit http://myap.h3c.com from a browser for a configuration terminal in a version earlier than
2448P10.
3. Enter the default username and password. For security purposes, change the password as
prompted after you access the Web interface, and then click
OK .
Anchor mode
When the AP operates in anchor AC mode, only wired connections are available.
To log in to the AP through a wired connection, enter the management IP address of VLAN-interface
1 from the CLI of the configuration terminal. If the default IP address has been changed, contact the
administrator to get the new IP address.