5
Figure 10 Attaching the mounting bracket to the Junction box
2.
Attach the AP to the mounting bracket. The procedure is the same as wall mounting and
Junction box mounting. For more information, see "
Mounting the AP on a ceiling
CAUTION:
The ceiling for installing the AP must be less than 18 mm (0.71 in) in thickness, and can bear a load
of 5 kg (11.02 lb). If you must install the AP on a ceiling not strong enough, use boards to reinforce
the ceiling.
To mount the AP on a ceiling:
1.
Remove the ceiling tile.
2.
Place the mounting bracket against the ceiling tile and mark the installation holes on the ceiling
tile. Drill two holes with a diameter of 6 mm (0.24 in) at the marked positions, as shown in
Figure 11 Drilling holes in the ceiling tile
3.
Thread the M4 × 30 mm pan-head screws through the installation holes in the mounting
bracket and into the holes in the ceiling tile. Fasten washers and nuts at the other side of the
ceiling to secure the mounting bracket to the ceiling, as shown in
