H3C WA Series, Configuration Manual

Page: 41 / 76

7-15
Task Remarks
Configuring the Link Type of Ports Optional
Configuring the Mode a Port Uses to Recognize/Send MSTP
Packets
Optional
Enabling MSTP Required
Configuring an MST Region Required
Configuring the MSTP Work Mode of the AP Optional
Configuring the Timeout Factor Optional
Configuring the Maximum Port Rate Optional
Configuring Ports as Edge Ports Optional
Configuring the Path Costs of Ports Optional
Configuring Port Priority Optional
Configuring the Link Type of Ports Optional
Configuring the Mode a Port Uses to Recognize/Send MSTP
Packets
Optional
Configuring the
leaf nodes
Enabling MSTP Required
Performing mCheck Optional
Configuring Digest Snooping Optional
Configuring No Agreement Check Optional
Configuring Protection Functions Optional
MSTP is mutually exclusive with any of the following functions on a port: service loopback, RRPP,
Smart Link, and BPDU tunneling of STP protocol packets.
Configuring MSTP
Configuring an MST Region
Make the following configurations on the root bridge and on the leaf nodes separately.
Follow these steps to configure an MST region:
To do... Use the command... Remarks
Enter system view
system-view
—
Enter MST region view
stp region-configuration
—
Configure the MST region name
region-name name
Optional
The MST region name is the
device MAC address by default.