2-12
2.2.2 Entering the RST Configuration Screen
Note
This section describes how to enter the Legacy BIOS configuration screen. The premise of
entering the RST configuration interface is that the operating mode of the RST onboard soft RAID
controller is set to RAID (for details, see
"
"), and the number
of disks connected to the controller is not less than two.
(1)
Power on or restart the server. After the screen shown in
is displayed during the BIOS
boot process, press
Ctrl
+
I
. It should be noted that the screen shown in
has a short
residence time and you need to press
Ctrl
+
I
quickly.
图
2-16
BIOS boot screen
(2)
Enter the RST configuration screen shown in
describes the screen). Refer to
the key operation tips in the lower part of the screen to navigate and modify settings.
