H3C UniServer R6900 G3, User Manual

Page: 105 / 214

7-24
Figure 7-29 Removing a GPU module
7.
Install a new GPU module. For more information, see " Installing a GPU module in a compute
module ."
8.
Install the compute module access panel. For more information, see " Replacing a compute
module access panel ."
9.
Install the compute module. For more information, see " Installing a compute module ."
10.
Install the removed security bezel. For more information, see " Installing the security bezel ."
11.
Connect the power cord. For more information, see " Connecting the power cord ."
12.
Power on the server. For more information, see " Powering on the server ."
Replacing a GPU module at the server rear
1.
Power off the server. For more information, see " Powering off the server ."
2.
Disconnect external cables from the riser card, if any.
3.
Remove the rear riser card and the GPU module. For more information, see " Replacing a riser
card and PCIe module at the server rear ."
4.
Install a new GPU module to the riser card and install the riser card. For more information, see
"
Installing riser cards and PCIe modules at the server rear ."
5.
Reconnect the external cables to the riser card.
6.
Connect the power cord. For more information, see " Connecting the power cord ."
7.
Power on the server. For more information, see " Powering on the server ."
Replacing an Ethernet adapter
WARNING!
To avoid bodily injury from hot surfaces, allow the server and its internal modules to cool before
touching them.