H3C UniServer R4900 G3, User Manual

Page: 118 / 299

109
Figure 137 Removing the RC-GPU/FHHL-2U-G3-2 riser card
6.
Remove the screw that secures the PCIe module, and then pull the PCIe module out of the slot,
as shown in
Figure 138 .
Figure 138 Removing a PCIe module
7.
Install a new riser card and PCIe module. For more information, see " Installing riser cards and
PCIe modules ."
8.
Install the access panel. For more information, see " Replacing the access panel ."
9.
Mount the server in the rack. For more information, see " Installing the server ."
10.
Connect the power cord. For more information, see " Connecting the power cord ."
11.
Power on the server. For more information, see " Powering on the server ."
Replacing an RC-Mezz-Riser-G3 Mezz PCIe riser
card
WARNING!
To avoid bodily injury from hot surfaces, allow the server and its internal modules to cool before
touching them.
To replace the RC-Mezz-Riser-G3 Mezz PCIe riser card:
1.
Power off the server. For more information, see " Powering off the server ."