31
Verifying the installation
Use one of the following methods to verify that the power supply is installed correctly:
•
Observe the power supply LED to verify that the power supply is operating correctly. For more
information about the power supply LED, see LEDs in "Rear panel."
•
Log in to HDM to verify that the power supply is operating correctly. For more information, see
HDM online help.
Installing riser cards and PCIe modules
The server provides three PCIe riser connectors on the system board to connect riser cards, which
hold PCIe modules. For more information about the connector locations, see "System board
components."
Guidelines
•
You can install a PCIe module in a PCIe slot for a larger-sized PCIe module. For example, an
LP PCIe module can be installed in a slot for an FHFL PCIe module.
•
A PCIe slot can supply power to the installed PCIe module if the maximum power consumption
of the module does not exceed 75 W. If the maximum power consumption exceeds 75 W, a
power cord is required. The following GPU modules require a power cord:
{
GPU-M4000-1-X.
{
GPU-K80-1.
{
GPU-M60-1-X.
{
GPU-P40-X.
{
GPU-M10-X.
{
GPU-P100.
{
GPU-V100-32G.
{
GPU-V100.
For more information about connecting the power cord, see "
Connecting the power cord of a
•
For more information about PCIe module and riser card compatibility, see "Riser cards."
•
The installation procedure and requirements vary by riser card model. Use
to identify
the installation procedure, requirements, and applicable PCIe riser connectors for each riser
card.
Table 6 Riser card installation location
Riser card model
PCIe riser
connectors
Installation procedure
RC-3GPU-R4900-G3
RC-FHHL-2U-G3-1
RS-3*FHHL-R4900
1 and 2
Installing an RC-3GPU-R4900-G3,
RC-FHHL-2U-G3-1, or RS-3*FHHL-R4900 riser
card and a PCIe module
RC-GPU/FHHL-2U-G3-1
1 and 2
Installing an RC-GPU/FHHL-2U-G3-1 riser card
and a PCIe module
RC-2*FHFL-2U-G3 1
Installing an RC-2*FHFL-2U-G3 riser card and a
PCIe module
NOTE:
A RC-Mezz-Riser-G3 Mezz PCIe riser card is
required.
