H3C UniServer R2700 G3, User Manual

Page: 54 / 226

6-18
12.
Power on the server. For more information, see " Powering on the server ."
Verifying the installation
Log in to HDM to verify that the GPU module is operating correctly. For more information, see HDM
online help.
Installing Ethernet adapters
Guidelines
You can install an mLOM Ethernet adapter only in the mLOM Ethernet adapter connector on the
system board. For more information about the connector location, see "System board components."
A riser card is required when you install a PCIe Ethernet adapter. For more information about PCIe
Ethernet adapter and riser card compatibility, see "Riser cards."
The server supports one HDM shared network port for out-of-band HDM management, which is
available if an NCSI-capable mLOM or PCIe Ethernet adapter is installed. By default, port 1 on the
mLOM Ethernet adapter (if any) is used as the HDM shared network port. If no mLOM Ethernet
adapter is installed, port 1 on the PCIe Ethernet adapter is used. You can change the HDM shared
network port as needed from the HDM Web interface.
Installing an mLOM Ethernet adapter
Procedure
1.
Power off the server. For more information, see " Powering off the server ."
2.
Install the mLOM Ethernet adapter:
a.
Insert the flathead screwdriver supplied with the server into the opening between the
mLOM Ethernet adapter blank and its handle, pull part of the blank out of the chassis with
screwdriver, and then pull the blank out of the chassis completely, as shown in
Figure 6-27 .
Figure 6-27 Removing the mLOM Ethernet adapter blank
b.
Insert the mLOM Ethernet adapter into the slot along the guide rails, and then fasten the
captive screws to secure the Ethernet adapter into place, as shown in
Figure 6-28 .