8-10
Table 8-9 NVMe data cable and the corresponding peer ports on the drive backplane and
8-port NVMe SSD expander module
Mark on the NVMe
data cable end
Port on the drive
backplane
Port on the 8-port NVMe SSD expander
module
NVMe 1
NVMe A1
NVMe 1
NVMe 2
NVMe A2
NVMe 2
NVMe 3
NVMe A3
NVMe 3
NVMe 4
NVMe A4
NVMe 4
NVMe 1
NVMe B1
NVMe 1
NVMe 2
NVMe B2
NVMe 2
NVMe 3
NVMe B3
NVMe 3
NVMe 4
NVMe B4
NVMe 4
Front 8SFF NVMe and rear 2SFF SAS/SATA drive cabling
For the 8SFF NVMe drive configuration, you must install two 4-port NVMe SSD expander modules in
PCIe slots 1 and 2 or an 8-port NVMe SSD expander module in PCIe slot 1.
Use
to determine the front drive cabling method depending on the type of the NVMe SSD
expander module.
Table 8-10 Front 8SFF NVMe and rear 2SFF SAS/SATA drive cabling methods
Storage controller
Front 8SFF drive
cabling method
Rear 2SFF drive
cabling method
•
One 8-port NVMe SSD expander module for the front
NVMe drives
•
Embedded RSTe RAID controller for the rear SAS/SATA
drives
See
See
.
•
Two 4-port NVMe SSD expander modules for the front
NVMe drives
•
Embedded RSTe RAID controller for the rear SAS/SATA
drives
. See
.
When connecting NVMe data cables, make sure you connect the peer ports with the correct NVMe
data cable. For 4-port and 8-port NVMe SSD expander modules, use
and
respectively, to determine the ports to be connected and the cable to use.
Front 8SFF SAS/SATA and front 2SFF NVMe drive cabling
For the 2SFF NVMe drive configuration, you must install a 4-port NVMe SSD expander module in
PCIe slot 1.
Use
to determine the front drive cabling method depending on the storage controller type.
Table 8-11 Front 8SFF SA/SATA and front 2SFF NVMe drive cabling methods
Storage controller
Front 8SFF drive cabling
method
Front 2SFF drive cabling
method
Embedded RSTe RAID controller
Mezzanine storage controller
See
Standard storage controller (in PCIe slot 2)