H3C SecPath M9000 NSQ1SUPB0 MPU, Manual

Page: 4 / 4

Manual Version: 6PW102-20170414 BOM: 3123A0R4
iv
3.
Place the card horizontally with the surface-mounted components facing upward. Pull outward the
ejector levers and gently push the card in along the slot guide rails until the card is in close contact
with the backplane. (See callout 1 in Figure 3 .)
4.
Push the ejector levers inward. (See callout 2 in Figure 3 .)
5.
Tighten the captive screws with a Phillips screwdriver to secure the card in the slot. (See callout 3
in
Figure 3 .)
Figure 3 Installing the NSQ1SUPB0
(1) Gently push the card in along the slot guide rails until the card is in close contact with the backplane.
(2) Push the ejector levers inward.
(3) Tighten the captive screws with a Phillips screwdriver, and installation is finished.
4.2 Removing the NSQ1SUPB0
1.
Use a Phillips screwdriver to loosen the captive screws at both sides of the card until all pressure
is released.
2.
Pull the ejector levers at both sides of the card outward, and pull the card along the guide rails until
it completely comes out of the backplane.
3.
Place the card on an anti-static workbench with the surface-mounted components up, or put it in an
anti-static bag.
If no new card is to be installed, install a filler panel to prevent dust and ensure good ventilation in
the device.
5 Software upgrade
For more information, see the release notes.
6 Obtaining documentation
To access the most up-to-date H3C product documentation on the H3C websit1.
Go to 2.
Choose the desired product category and model.
Copyright © 2017 New H3C Technologies Co., Ltd.