45
−
If the state of the port is
DOWN
, locate the reason for the port to be down. The possible
reasons include: its uplink device is configured with monitor link, the link of the port fails,
or the port is shut down. Further troubleshoot the problem based on the reason for the
port to be down.
−
If the state of the port is
STANDBY
, perform an active/standby switchover in the smart
link group.
4.
Examine the following configurations that might cause packet loss:
{
VLAN configuration
—Execute the
display this
command in Ethernet interface view to
verify that the port is in the VLAN of the packets. If it is not, add the port to the VLAN.
{
Blackhole MAC address entries
—Execute the
display mac-address blackhole
command to display blackhole MAC address entries. If the packets are discarded because
they match a blackhole MAC address entry, delete the entry. To delete the blackhole MAC
address entry, execute the
undo mac-address blackhole mac
-
address
vlan
vlan
-
id
command.
{
Rate limit
—Execute the
display qos lr interface
command to display the rate limit
configuration on the port. If rate limit is configured on the port, make sure the committed
information rate (CIR) and the committed burst size (CBS) are appropriate. To adjust the
CIR and CBS values, execute the
qos lr
{
inbound
|
outbound
}
cir
committed-information-rate
[
cbs
committed-burst-size
] command.
{
Storm suppression
—Execute the
display this
command in Ethernet interface view to
display the configuration of storm suppression. Storm suppression includes broadcast
suppression, multicast suppression, and unknown unicast suppression. To adjust the
suppression thresholds, execute the
broadcast-suppression
,
multicast-suppression
,
and
unicast-suppression
commands, respectively.
5.
Verify that no congestion occurs by using the
display qos queue-statistics interface
command.
If congestion occurs, locate and resolve the problem by referencing related congestion
management documents.
6.
If the problem persists, contact Hewlett Packard Enterprise Support.
Related commands
This section lists the commands that you might use for troubleshooting Layer 2 packet loss failure.
Command
Description
display interface
Displays Ethernet interface information.
display ip source binding
/
display
ipv6 source binding
Displays source guard binding entries.
display link-aggregation verbose
Displays detailed information about the aggregation groups that
correspond to the aggregate interfaces.
display mac-address blackhole
Displays blackhole MAC address entries.
