1-10
display ip routing-table ip-prefix
Syntax
display ip routing-table ip-prefix
ip-prefix-name
[
verbose
]
View
Any view
Default Level
1: Monitor level
Parameters
ip-prefix-name
: IP prefix list name, a string of 1 to 19 characters.
verbose
: Displays detailed routing table information, including inactive routes. With this argument
absent, the command displays only brief information about active routes.
Description
Use the
display ip routing-table ip-prefix
command to display information about routes permitted
by a specified prefix list.
This command is usually used together with route policy display commands. If the specified prefix
list is not configured, the detailed information about all routes (with the
verbose
keyword) or brief
information about all active routes (without the
verbose
keyword) is displayed.
Examples
# Configure a prefix list named
test
that matches routes with prefix 2.2.2.0 and a mask length
between 24 and 32.
<Sysname> system-view
[Sysname] ip ip-prefix test permit 2.2.2.0 24 less-equal 32
# Display brief information about active routes matching the prefix list
test
.
[Sysname] display ip routing-table ip-prefix test
Routes Matched by Prefix list : test
Summary Count : 2
Destination/Mask Proto Pre Cost NextHop Interface
2.2.2.0/24 Direct 0 0 2.2.2.1 Vlan2
2.2.2.1/32 Direct 0 0 127.0.0.1 InLoop0
For detailed description of the above output, see
# Display detailed information about both active and inactive routes that match IP prefix list
test
.
[Sysname] display ip routing-table ip-prefix test verbose
Routes Matched by Prefix list test :
Summary Count : 2
Destination: 2.2.2.0/24
Protocol: Direct Process ID: 0
Preference: 0 Cost: 0
NextHop: 2.2.2.1 Interface: Vlan-interface2
RelyNextHop: 0.0.0.0 Neighbour: 0.0.0.0
Tunnel ID: 0x0 Label: NULL
State: Active Adv Age: 1d00h20m52s
Tag: 0
