H3C S5500-SI Series, Operation Manual

Page: 357 / 1217

1-2
z
Enabling IPv6 packet forwarding
z
Ensuring that the neighboring nodes are IPv6 reachable
Configuring an IPv6 Static Route
Follow these steps to configure an IPv6 static route:
To do… Use the commands… Remarks
Enter system view system-view —
Configure an IPv6 static route
ipv6 route-static ipv6-address
prefix-length [ interface-type
interface-number ] nexthop-address
[ preference preference-value ]
Required
The default
preference of IPv6
static routes is 60.
Displaying and Maintaining IPv6 Static Routes
To do… Use the command… Remarks
Display IPv6 static route
information display ipv6 routing-table protocol
static [ inactive | verbose ]
Available in any view
Remove all IPv6 static routes delete ipv6 static-routes all Available in system view
Using the undo ipv6 route-static command can delete a single IPv6 static route, while using the
delete ipv6 static-routes all command deletes all IPv6 static routes including the default route.
IPv6 Static Routing Configuration Example
Network requirements
With IPv6 static routes configured, all hosts and switches can interact with each other.
Figure 1-1 Network diagram for static routes