H3C S5500-SI Series, Operation Manual

Page: 321 / 1217

1-2
z
IP address of the next hop: Specifies the address of the next router on the path. If only the
outbound interface is configured, its address will be the IP address of the next hop.
z
Priority for the route. Routes to the same destination but having different nexthops may have
different priorities and be found by various routing protocols or manually configured. The optimal
route is the one with the highest priority (with the smallest metric).
Routes can be divided into two categories by destination:
z
Subnet routes: The destination is a subnet.
z
Host routes: The destination is a host.
Based on whether the destination is directly connected to a given router, routes can be divided into:
z
Direct routes: The destination is directly connected to the router.
z
Indirect routes: The destination is not directly connected to the router.
To prevent the routing table from getting too large, you can configure a default route. All packets without
matching any entry in the routing table will be forwarded through the default route.
In Figure 1-1 , the IP address on each cloud represents the address of the network. Router G is
connected to three networks and therefore has three IP addresses for its three physical interfaces. Its
routing table is shown under the network topology.
Figure 1-1 A sample routing table
Router A
Router B
Router H
Router E
16.0.0.2
17.0.0.3
15.0.0.0
12.0.0.0
17.0.0.0
11.0.0.0 16.0.0.0
13.0.0.0
14.0.0.0
Router C
Router D
Router F
Router G
11.0.0.1
12.0.0.1
12.0.0.2
15.0.0.1
15.0.0.2
17.0.0.1
16.0.0.1
13.0.0.1
13.0.0.2
14.0.0.1
14.0.0.2
14.0.0.3
14.0.0.4
17.0.0.2
11.0.0.2
13.0.0.3
Destination Network Nexthop Interface
11.0.0.0 11.0.0.1 2
12.0.0.0 12.0.0.1 1
13.0.0.0 12.0.0.2 1
14.0.0.0 14.0.0.4 3
15.0.0.0 14.0.0.2 3
16.0.0.0 14.0.0.2 3
17.0.0.0 11.0.0.2 2