339
Figure 86
Network diagram
Device
Interface
IP address
Device
Interface
IP address
CE 1
Vlan-int11
10.1.1.1/24
P
Loop0
2.2.2.9/32
Vlan-int12
100.1.1.1/24
Vlan-int11 30.1.1.1/24
PE 1
Loop0
1.1.1.9/32
Vlan-int12
20.1.1.2/24
Vlan-int11
10.1.1.2/24
PE 2
Loop0
3.3.3.9/32
Vlan-int12
20.1.1.1/24
Vlan-int11 30.1.1.2/24
CE 2
Vlan-int12
10.2.1.1/24
Vlan-int12
10.2.1.2/24
Vlan-int13
200.1.1.1/24
Configuration procedure
1.
Configuring basic MPLS L3VPN:
{
Configure OSPF on the MPLS backbone to allow the PEs and P device to learn the routes of the
loopback interfaces from each other.
{
Configure MPLS basic capability and MPLS LDP on the MPLS backbone to establish LDP LSPs.
{
Establish MP-IBGP peer relationship between the PEs to advertise VPN IPv4 routes.
{
Configure the VPN instance of VPN 1 on PE 2 to allow CE 2 to access the network.
{
Configure the VPN instance of VPN 1 on PE 1 to allow CE 1 to access the network.
{
Configure BGP between PE 1 and CE 1, and between PE 2 and CE 2 to inject routes of CEs into
PEs.
After completing the configurations, issue the
display ip routing-table
command on CE 2. You can
see that CE 2 has learned the route to network segment 10.1.1.0/24, where the interface used by
CE 1 to access PE 1 resides; but has not learned the route to the VPN (100.1.1.0/24) behind CE
1. The situation on CE 1 is similar.
<CE2> display ip routing-table
Routing Tables: Public
Destinations : 8 Routes : 8
Destination/Mask Proto Pre Cost NextHop Interface
10.1.1.0/24 BGP 255 0 10.2.1.2 Vlan11
10.1.1.1/32 BGP 255 0 10.2.1.2 Vlan11
